Energy management for buildings without a BMS

Your building is running blind. Let’s make it visible.

Live energy monitoring, smart HVAC control and leak detection, installed, connected and optimized by our team. Built for commercial buildings that don’t have a building management system, with a focus today on nursing homes and senior living.

The problem

No BMS means no visibility.

Large office buildings run central plants, so they usually have a building management system (BMS) watching everything. Most nursing homes, senior living communities, schools, warehouses and smaller commercial buildings don’t. That leaves the questions that matter unanswered:

  • Is the HVAC running in rooms nobody is using?
  • Why is one wing always too warm and the dining room too cold?
  • Is there a leak behind the laundry machines right now?
  • What is really driving this month’s electric bill?

Too often, you find out when a resident is uncomfortable, a ceiling tile stains, or the bill arrives.

The solution

BOSS Energy makes your building visible.

We install wireless sensors and smart thermostats from our hardware partner Milesight throughout your building. They report over LoRaWAN, right through walls and floors, to a gateway in your electrical room and on to your live BOSS Energy dashboard.

  • See energy use as it happens
  • Control HVAC from one screen
  • Get alerted to leaks right away
  • Compare every building you own in one dashboard

What we monitor & control

One system for every space that matters.

Tap a point on the building, or choose a space below.

Your live dashboard

Your whole building, live, in one place.

Watch energy use, check every room’s temperature, adjust thermostats and get leak alerts from one BOSS Energy dashboard, on your computer or phone.

Sample dashboard with demo data.

Multiple buildings

Own more than one building? Manage them all from one dashboard.

Put every facility, campus or store you own under one BOSS Energy account. Compare energy use side by side, spot the building that’s drifting, and manage every site from one login.

  • All your buildings in one place
  • Compare energy use between sites
  • Spot the site that needs attention first

How we save

Real experts. Your real data.

BOSS Energy isn’t software you have to figure out alone. Our specialists study your building’s energy data, both how much you use (kWh) and your power peaks (kW), and build your HVAC schedules and peak-reduction plan for you. Then we keep refining them as your building changes. It’s all part of your subscription.

  1. Your building

    Live kWh and kW data from your energy monitoring and thermostats.

  2. Our team

    BOSS Energy specialists study when, where and why your building uses energy.

  3. Your custom plan

    HVAC schedules and a peak-demand plan built for your community.

  4. Your thermostats

    The plan runs automatically. We keep reviewing and refining it.

HVAC scheduling

Heat and cool people, not empty rooms.

Offices, therapy and activity rooms, dining, the kitchen and laundry all have quiet hours. Our team sets each space back when it’s unused and brings it back to comfort before people arrive. Resident rooms stay comfortable 24/7. We can also lock setpoint ranges, so no thermostat gets left at an extreme.

6:00 AM
Resident rooms
Nurses’ stations
Dining room
Therapy & activity rooms
Admin offices
Kitchen
Laundry
Vacant resident room (until move-in)
Comfort Eased back (saving)

Example schedule. Your plan is built from your building’s own data.

Peak demand reduction

Flatten the spike that sets your bill.

Commercial electric bills include a demand charge based on your building’s single highest spike in power use each month. One bad 15 minutes can raise the whole month’s bill, and some utilities keep a high peak on your bill for months afterward.

Our team studies when your peaks happen and plans around them, without touching resident comfort:

  • 1Staggered start-upsHVAC units start a few minutes apart instead of all at once.
  • 2Pre-coolingCool the building during cooler morning hours, then coast through the afternoon.
  • 3Brief, small adjustmentsA degree or two, briefly, in non-critical areas during a peak. Never resident rooms.
Building power use over one day Without BOSS Energy, everything starts at once and a tall spike sets the month's demand charge. With BOSS Energy, start-ups are staggered and the building pre-cools, so the curve stays smooth and the peak is lower.
Illustration only. Not actual data.

Why LoRaWAN

A network built for buildings, not for laptops.

Every BOSS Energy device runs on LoRaWAN, a long-range, low-power wireless network designed for sensors. Here’s why it beats Wi-Fi in a busy building:

Reach

LoRaWANLong range, right through walls, floors and long corridors.

Wi-FiStruggles through concrete, stairwells and long wings.

Power

LoRaWANSensors use so little power they run for years on batteries. The gateway plugs into building power.

Wi-FiPower-hungry devices that need frequent charging or wiring.

Independence

LoRaWANIts own network. No dependence on your Wi-Fi or IT staff.

Wi-FiShares your Wi-Fi with residents, staff and passwords.

Hardware partner: Milesight

Our smart thermostats and leak detection sensors come from our hardware partner Milesight, all on LoRaWAN, installed and connected by our team.

How it works

From blind to visible in five steps.

  1. 1

    Assess

    We collect data about your building’s HVAC system.

  2. 2

    Equip

    You get the Milesight devices your building needs from us: smart thermostats and leak detection sensors, all on LoRaWAN.

  3. 3

    Install & connect

    We install everything and connect it to your live BOSS Energy dashboard.

  4. 4

    Analyze & optimize

    Our team studies your kWh and kW data and builds custom HVAC schedules and a peak-demand plan, then keeps refining them over time.

  5. 5

    See & control

    Monitor energy, control HVAC and get leak alerts from one dashboard, with ongoing service through your subscription.

Who we serve

For every building without a BMS.

Nursing homes and senior living are our focus today, but BOSS Energy works in any commercial building that doesn’t have a building management system.

Current focus

Nursing homes & senior living

Our focus today. Steady comfort for residents 24/7, savings in every space around them.

Schools

Classrooms, gyms and offices that sit empty nights, weekends and summers, with no system watching.

Warehouses

Large open spaces heated and cooled around the clock, whether a shift is working or not.

Manufacturing

Plants with heavy equipment and big power peaks, where demand charges add up fast.

Retail stores

Stores where HVAC runs before opening and after closing, and leaks go unnoticed until morning.

Owners with many sites

Facilities, campuses or store chains, all compared side by side in one dashboard.

Our guarantee

Guaranteed savings.

We stand behind our system: BOSS Energy guarantees savings for your building. Tell us a little about your building and we’ll reach out to set up a meeting.

Prefer email?

Request a meeting